Has anyone ever added lights into a fiberglass topper? I have an ARE shell, was going to put lights on some sliders as camp lights, and rear lights on bars welded to the rear tire carrier, but I was thinking, can I cut into and mold/seal a set of rigid led lights into the shell itself?
They would be higher up, tucked in and unlikely to get ripped off by branches...etc...
Anyone have experience with this?
working with older pic here...But No lights, no new sliders etc:
Example of where they would be mounted on the sliders, all the way back, on top, in a fabricated box, pointing forward and out, shooting towards 10 and 2 probably, either D2 dually floods or diffused.
And then, if it can be done, well, with a reasonable cost...fabbed into the fiber glass shell, pointing down and out from the top.
and of course the lights:
They would be higher up, tucked in and unlikely to get ripped off by branches...etc...
Anyone have experience with this?
working with older pic here...But No lights, no new sliders etc:
Example of where they would be mounted on the sliders, all the way back, on top, in a fabricated box, pointing forward and out, shooting towards 10 and 2 probably, either D2 dually floods or diffused.
And then, if it can be done, well, with a reasonable cost...fabbed into the fiber glass shell, pointing down and out from the top.
and of course the lights: