CAN Bus question

BLU60

New member
2016 G550

Good day all:

I am going to install a switch panel that requires three 12V triggers. Ignition, high beams, and side marker lights.

Has anyone any experience with:

http://www.canm8.com/can-bus-interfaces/multi-output-interfaces/canm8-idr8.html

and if so where would I get the signals for this interface for this wiring harness that clamps around the Hi and low CAN Bus (instructions say it’s near the ignition key but that’s it)

http://www.canm8.com/cannect-contactless-reader/canm8-cannect-contactless-reader.html

The switch panel I am using is:

http://www.switchpros.com/

I appreciate any help. Stay tuned for a build thread!
 

crofrog

New member
Did you ever move forward with the canm8 product? I'm looking at as well for adding auxiliary lights.
 

BLU60

New member
Did you ever move forward with the canm8 product? I'm looking at as well for adding auxiliary lights.
I did; however, the clip on sensor could not get a strong enough signal so we had to splice into the factory bus wires. It all works as advertised. Nice to be able to link a light bar with the factory hi-beams.
 

crofrog

New member
I did; however, the clip on sensor could not get a strong enough signal so we had to splice into the factory bus wires. It all works as advertised. Nice to be able to link a light bar with the factory hi-beams.

Awesome thank you!
 

Forum statistics

Threads
186,809
Messages
2,890,343
Members
227,012
Latest member
dalewelsh
Top