Just ordered the BJ spacers from 4Crawler Offroad. After looking at his LSPV bracket, I can make my own for whatever lift I put on the truck...
Still trying to decide on the shocks. Bilstein or OME. Going to see how much It'll cost to get the springs and shocks from Toyota of Dallas.
Hey Mike, its Jacque that I need to talk to?
I've been working on some rock sliders.... :sombrero:
The vertical bits are going to have a plate on top. The sliders will welded to the frame itself and then bolted to the body in those two spots. I reckon this will give plenty of support for them bouncing on rocks. I've not really inspected any other sliders before... infact, I didnt look up what other folks are doing before conquering this project! I'll have to find something to test them on I guess. An after thought.... one that I guess experience or research would have told me otherwise..... I only butted the frame supports to the outer part of the slider. I'm not sure how well those welds will hold? The welds have good penetration, but again, I lack the experience to judge. Maybe I need to add some gussets plates to the top and bottom at each butt joint?
This is actually my first big welding project....
How are my welds? I'm using a Lincoln Welder 125.