Firebear MD718
Observer
Well as with Oliverlove, I too did a ARB install only with a 2010 Access Cab, everything went as expected, well almost except when placing the outer support bracket and I went to crank in the recommended touqure at 57lbs to the bolt that went through the main frame it started to crush the passenger side frame, I rechecked the touqure wrench, then rechecked it with another wrench and setting and tested it on another test set up and that worked will except the same thing happened, went to the Drive side and started to do the same when it started to crush the same was . . . well not sure what to now, I've heard and seen the rear frame mode on older 2nd Gen. Tacoma's but not the front just behind the crush zone.
Thinking I might weld some support plating in, but thought I might run it through here to see if it's happened else where . . . Help !!
Thinking I might weld some support plating in, but thought I might run it through here to see if it's happened else where . . . Help !!