RAM5500 CAMPERTHING
OG Portal Member #183
Our next video is up! If you are enjoying following along make sure to subscribe.
Excellent
Our next video is up! If you are enjoying following along make sure to subscribe.
That was very interesting, however you mentioned the spring mounts, showed approximately where they were going, but didn't show the finished mounts. Or, is it that you haven't done them yet?
Excellent build, been following it almost since you started it.
Damn, that is a magical portal! I saw two short hair dogs go through and then reappear as a German Shepard.Episode 4 is up!
Rolling along very nicely. I really like the method to remove the rear window, but, how did you get the blade in, in the first place?
I always chuckle when i see "pass throughs" and think theyre is no way in hell the folks would actually fit through them. Especially yours, and then....
The end of your new video is freaking awesome and impressive! Bravo!
Video of you guys climbing through the pass through please ?
Yall must be tiny, I don’t even think I could get my legs through that ?
Hey you asked for it!
Your series was a major source of inspiration both to do the project in the first place, and to document it on YouTube. Its fun to be a member of this great community!
Near the bottom corner it was possible to *carefully* sneak it in.
Hey you asked for it!
Your series was a major source of inspiration both to do the project in the first place, and to document it on YouTube. Its fun to be a member of this great community!
whats the plan for connection the interior panel together? fiberglassing the joint? Also, did you test the rivet to see if they delaminate the panel from the foam when you put them in? i know they say to not screw anything in fiberglass composite panel so i m wondering? i really love your idea of individual panel like this as it s much more managable to do vs building 1 big panel for each side!
keep the good work! looking forward to the next update!