now for my pride of this build....
got some more done on the 3 axis tounge it will allow the trailer to move up and down side to side like a normal trailer but will also allow the trailer to roll over without dragging the jeep with it
Hitch top view normal stance
hitch top view turned 90 degrees also before i tightened the nut there is a gap on the front but not what you see here
The tube you see is actually DOM tube I had left from my cage build the main piviot is a 1 1/4" grade 8 bolt it piviots in a peice of DOM with about a paper width from the bolt to the DOM. Then the DOM was pressed into a chunk of 2" x2" 1/4" wall sq tube should be plenty strong to handle abuse. The toung is but welded together and then a 1/8" plate welded between the two NO way this sucker is coming apart!!!
here is some more... the front 1/2 of the like now I just need to make the hitch on for the 2" receiver.
This is how it will bolt together using a 3/4 grade 8 bolt. This link is basically like a shackle 3/8th inch sides and the main plate is 1" steel plate with a greasable bushing in it to allow a pin to be dropped in the hitch and a pivot point for side to side movement.