I have read through a few threads that have been very helpful in assessing and giving me direction in my rebuild, specifically SLO's Skamper thread, Jrod420's 1993 Starcraft Roadmaster threat, and Scoutmaster's FWC rebuild. I started a thread on RV.Net but got little attetnion and found this site last weekend and seems to be much more active. I bought the camper early this summer in Phoenix, AZ and drive it home to Homer, AK. The interior looked clean but I wish I knew now what I did then! I knew there was an issue on the front of the roof and the PO has caulked up the rear corners but when I got into these issues I have realized that all the roof sides are bad and I am in the middle of refabricating side walls. I will post pictures after this post.
My main issue I am running up against right now is the roof itself. I have removed all the wood that lines the edge of the roof and have found that the two pieces of wood that span the distance from side to side and divide the roof into thirds is rooted and most of the back third of the foam is wet. I am told that the white foam does not dry out! I am not excited about removing the aluminum skin. Any suggestions? Thanks in advance!
My main issue I am running up against right now is the roof itself. I have removed all the wood that lines the edge of the roof and have found that the two pieces of wood that span the distance from side to side and divide the roof into thirds is rooted and most of the back third of the foam is wet. I am told that the white foam does not dry out! I am not excited about removing the aluminum skin. Any suggestions? Thanks in advance!