It's been a busy week, had to order a new exhaust to meet Pa inspection. Looked around extensively and never found one I liked the sound of. Either too loud or to ricer ish. I ended up going with Gibson oddly enough because of all their negative reviews. Almost all of which were for the sound quality, "sounds stock" or "quiet and boring." The usual PITA to remove the stock exhaust, but less than half an hour to bolt the new one on.
Over all, it has a deep rumble at idle and low RPMs and unnoticeable difference between the stock at higher RPMs. Zero performance improvement noticed. The fit would have been perfect, but the exit point was not designed with an after market shackle in mind. A little bit of adjusting or a small extension piece later and it works.
Old one off
New one on
Next up:
long and the short of it, my truck spends a lot of time running while parked and usually under load. My brother has the same louvers on his drag mustang and they help quite a bit. He sent me a link and I ordered a set that day.
Parts acquired and I started the install. Took the hood off to make things easier.
Measure, tape, measure again, tape...
Holes cut, cleaned, painted
Came out awesome
Also added some more horsepower! Can you tell I like stickers too much?