Search results

  1. Glorybigs

    Looking for DIY RTT anti-condensation solution

    Driwall™ Rainscreen http://www.keenebuilding.com/residential-driwall-rainscreen-020-1.aspx You can tank the guys on Pirate - they tested it and it works great and does not compress.
  2. Glorybigs

    TRD Pro as a out-of-the-box overlander/DD?

    Manual Tacoma trannys fail all the time. FWIW I would get an automatic.
  3. Glorybigs

    Blue Sea ACR Wiring Question

    I'm no expert but I've been running my ACR for a couple of years so I'll throw this out there. It looks like you show both batt + being run to your fuse panel. The ACR will see the drain but will not be able to break the circuit the way your diagram is shown. The fuse panel will be able to...
  4. Glorybigs

    California fuel storage containers...

    You can not be cited for using an older fuel container, the carb regs relate to what containers/spouts and what service parts can be manufactured/sold. But you still live there and pay them tax money....Go Galt or suffer the fools.
  5. Glorybigs

    FJ40 Revival Design Project

    http://www.expeditionportal.com/forum/threads/121743-FJ40-Revival-Design-Project?p=1510375#post1510375 This may be a spammer
  6. Glorybigs

    Who has fallen out of their rtt

    Large Gatorade bottle or my personal favorite is the large mouth coorslight cans with the screw on tops.
  7. Glorybigs

    FJ40 Revival Design Project

    Done but the generic questions didn't really lead me to believe the information will assist you in your stated quest. Here are some really basic deign standards you could use. Design wheel well openings to accommodate tires with a 35" od and with minor modification a 37" od tire. Design...
  8. Glorybigs

    2nd Gen Rear HC Bumper Build (Pics)

    Comp4x4 is a very well respected name in the business of rear swing out parts. The axles are not designed for the leverage being put on them with the tire swing out and they will fail, when depends on many variables. I'm not trying to argue a point, I'm stating a fact. Your still in the build...
  9. Glorybigs

    2nd Gen Rear HC Bumper Build (Pics)

    Really nice work. A couple of suggestions... 1. Pick up some heavy duty / truck, door edge guard to finish off your cut off bed sides. 2. Regarding the axle pivot, single shear will fail. Before it fails figure a way to capture the top so it's in double shear.
  10. Glorybigs

    Show us your Toyota 4runner, tacoma or truck.

    Current setup Entering Death Valley Saline Valley
  11. Glorybigs

    Isolator or just straight parallel???

    This will solve your problem... BLUESEA ML-ACR it will also prevent your primary battery from discharging beyond a safe limit due to loads. Has manual override, as well as switch override if you want to control the relay from inside the cab. I would put this setup against any "offroad" dual...
  12. Glorybigs

    Tube benders

    JD2 Model3 elec/hydro - I researched the heck out of different benders and settled on this one. It is a quality unit and they have great customer support.
  13. Glorybigs

    Camp Stereo

    Camp stereo thread should be about camp stereos, it should not be filled up with opinions from people on outdoor audible edict. But since opinions are being expressed... This forum is all about expedition outings, not driving over to a camp ground and enjoying a spot where someone else thinks...
  14. Glorybigs

    Nitro Gear Packages Land Cruiser, Tacoma, Tundra, FJ Cruiser, More! 1 part number!

    To those looking into regearing... I did a ton of research before deciding to go with Nitro R&P gear sets, I went with 4.88 in my 07' Tacoma. I've been running them for over 6 months now with lots of hard wheeling on them, they have performed flawlessly. They were surprisingly quiet from the...
  15. Glorybigs

    FS: Aircraft Track/Tie Down Track

    I will take them, PM sent.
  16. Glorybigs

    The Josh's M416 Trailer Build

    Looks well done Josh! So when are you headed south for a run?? I want to chk it out in person.
  17. Glorybigs

    Square tubing thickness

    .120 wall would be fine, actually it would be overkill, that said I would use it. Keep in mind, almost every major manufacturer of rock siders uses .120 wall tubing. If it can carry the weight of the truck bouncing off of a boulder, I'm confident it can hold your trailer together.
  18. Glorybigs

    Abandoned Mine-Sierra's

    No nannies needed..this is ExPo, but thanks anyways.
  19. Glorybigs

    Box Rocket '03 DC Tacoma Build

    Legal in NV as well. There are still many, many free states as opposed to the few nanny states. Freedom, it's what Expo is all about.
Top